Network Modules; 10-Gb Network Module - Cisco Firepower 2100 Series Hardware Installation Manual

Overview
Caution
Note
For More Information
• See
• See
• See
• See
• See

Network Modules

The Firepower 2130 and 2140 contain one network module slot that provides optical or electrical network
interfaces. Network modules are optional, removable I/O modules that provide either additional ports or
different interface types. The Firepower network module plugs into the chassis on the front panel.
For More Information
• See
• See
• See
• See

10-Gb Network Module

The following figure shows the front panel of the 10-Gb network module (FPR2K-NM-8X10G). The
FPR2K-NM-8X10G is a single-wide module that supports hot swapping. The eight ports are numbered from
top to bottom, left to right.
If you move the power switch to the OFF position before the shutdown command sequence is complete
or if you remove the system power cords before the graceful shutdown is complete, disk corruption can
occur.
After removing power from the chassis by unplugging the power cord, wait at least 10 seconds before
turning power back ON.
Remove and Replace the Power Supply Module, on page 68
replacing the power supply module in the Firepower 2130 and 2140.
Remove and Replace the Fan Tray, on page 80
fan tray in the Firepower 2130 and 2140.
Ground the Chassis, on page 60
Power Supply Modules, on page 27
Front Panel LEDs, on page 12
10-Gb Network Module, on page 19
1-Gb Network Module , on page 21
Supported SFP/SFP+ Transceivers, on page 31
Install, Remove, and Replace the Network Module, on page 63
replacing network modules.
for the procedure for removing and replacing the
for the procedure for using the grounding lug to ground the chassis.
for a description of the power supply module LEDs.
for a description of the fan LEDs.
for a description of the 10-Gb network module.
for a description of the 1-Gb network module.
for a list of supported SFPs.
Cisco Firepower 2100 Series Hardware Installation Guide
Network Modules
for the procedure for removing and
for the procedure for removing and
19