MTX 952027 User Manual page 9

1. Make sure the device is turned off. Set the saw on a flat surface.
2. Establish a guard of a chain brake in working position, having pulled the lever on itself. Make sure that the
chain rotates around the guide bar (Pic. 4).
3. Loosen both nuts (A) securing the guide bar and the protective cover. Remove the protective cover along
with the chain brake flap (B) (Pic. 5).
4. Install the guide bar so that the slot of the guide bar coincides with both bolts (C) (Pic. 6).
5. Spread the chain in a circle, guiding the cutting edges (D) in accordance with the indications on the
protective cover and on the chain of the chainsaw (Pic. 7).
6. Slide chain onto drive sprocket (E). Check that the chain links between the sprocket teeth are well placed.
(Pic. 8).
7. Insert the links into the groove of the guide bar (F) around the periphery (Pic. 8).
8. Rotate the chain to make sure that the teeth of the chain caught in the teeth of the sprocket wheel.
9. Replace the cover shield together with the brake circuit so that the bolt stood in a hole intended for them,
and the chain tension adjustment pin stood in the lower opening of the guide bar it (Pic. 9).
Pic. 4
C
Pic. 6
E
E
GASOLINE CHAIN SAW
B
Pic. 5
F
Pic. 8
A
D
Pic. 7
9