Troubleshooting - MTX 952027 User Manual

Fault
The saw does not start.
The saw starts up
but the engine runs at
low power.
The engine is stopped. Incorrect carburetor setting.
The engine is
unstable.
Increased vibration,
noise.
The chain brake does
not work.
The chain is not
lubricated.
Excessive smoke.
Maintenance should be carried out in specialized service centers.

TROUBLESHOOTING

Possible reason
Violation of starting procedures.
Incorrect carburetor setting.
Spark plug contamination.
Fuel filter clogged.
Incorrect position of the choke
control.
Candle contamination.
Air filter is dirty.
Incorrect carburetor setting.
Incorrect spark plug clearance.
The engine mount is loose.
The brake mechanism is damaged.
Damaged oil pump.
The oil tank is empty.
The oil filter is clogged.
Incorrect carburetor setting.
Improperly prepared fuel mixture.
GASOLINE CHAIN SAW
Remedy
Follow the instructions in the manual.
Adjust the carburetor at an authorized
service.
Clean the candle / adjust the clearance or
replace the candle.
Replace fuel filter.
Adjust the choke.
Clean the candle / adjust the clearance or
replace the candle.
Remove, clean and reinstall the filter.
Adjust the carburetor at an authorized
service.
Adjust the carburetor at an authorized
service.
Clean the candle / adjust the clearance or
replace the candle.
Contact an authorized service center.
Contact an authorized service center.
Contact an authorized service center.
Add chain saw oil.
Contact an authorized service center.
Adjust the carburetor at an authorized
service.
Use a properly prepared fuel mixture, the
proportion is indicated on a can of oil for a
2-stroke ICE.
21