Table of Contents
Advertisement
Useful Information
Troubleshooting
General use
Problem
The unit does not work.
I cannot hear a dial tone.
"Recharge battery" is
displayed and I cannot
perform the following
operations:
– recording or erasing a
customized ringer
– editing a title for a
customized ringer
Programmable settings
Problem
I cannot program items.
While programming, the
handset starts to ring.
74
For assistance, please visit http://www.panasonic.com/phonehelp
Cause/solution
L Make sure that the battery is installed correctly and fully
charged (page 12).
L Check the connections (page 9 – 11).
L Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset has not been registered to the base unit.
Register the handset (page 48).
L Confirm that the telephone line cord is properly
connected (page 10).
L Disconnect the base unit from the telephone line and
connect a known working telephone. If the working
telephone operates properly, contact our service
personnel to have the unit repaired. If the working
telephone does not operate properly, contact your
telephone service provider.
L The battery power is low. Fully charge the battery (page
12) and try again.
Cause/solution
L While another user is listening to messages or the
answering system is answering a call, you cannot
program items. Try again later.
L A call is being received. Answer the call and start again
after hanging up.
Advertisement
Table of Contents
