Attaching The Backplate; Inserting The Graphics Card Into The Chassis - EK-Quantum Vector2 XC3 RTX 3080 D-RGB User Manual

ATTACHING THE BACKPLATE

7
6
4

INSERTING THE GRAPHICS CARD INTO THE CHASSIS

Carefully lift your graphics card with the installed water block and
insert it into your PC's motherboard PCI Express expansion slot.
Please keep in mind that your graphics card is heavier than before it
was equipped with the water block.
You need to be very careful when handling the graphics
card. Avoid all unnecessary manipulation of the water block
assembly that might damage your card or water block.
BACKPLATE
1
3
5
2
8
STEP 1
STEP 1
Place the backplate with eight (8) M2.5 x 8 AX1 Screws and Standoffs
onto the PCB. Make sure all the holes are aligned.
Tighten the screws according to the numerical order shown in
the image!
Do not use excessive force!
For this step, you will need:
Phillips Head Screwdriver
- 16 -