Preparing The Backplate - EK-Quantum Vector2 XC3 RTX 3080 D-RGB User Manual

Gpu water block

Hide thumbs Also See for Vector2 XC3 RTX 3080 D-RGB:

Table of Contents

PREPARING THE BACKPLATE

Thermal Pad F – 1.0 mm (120 x 16 mm)

120 mm

Thermal Pad F – 1.5 mm (120 x 16 mm)

120 mm

Thermal Pad F – 2.0 mm (120 x 16 mm)

120 mm

STEP 1

After attaching the water block, a few more thermal pads need to be

cut into smaller pieces to cover all the necessary components.

EK made sure to provide you with more than an adequate quantity of

thermal pads to complete this step.

1 mm

Replacement thermal pads:

Thermal Pad F 1.0 mm – (120 x 16mm) EAN: 3830046996732

1.5 mm

Thermal Pad F 1.5 mm – (120 x 16mm) EAN: 3830046996749

Thermal Pad F 2.0 mm – (120 x 16mm) EAN: 3830046996756

For this step, you will need:

2 mm

STEP 1

- 14 -

CAUTION: You must remove the protective foil from both

sides of the thermal pad before installation.

Scissors

Table of Contents

Do you have a question about the Vector2 XC3 RTX 3080 D-RGB and is the answer not in the manual?

Vector2 xc3 rtx 3090 d-rgbVector2 xtreme rtx 3080/90 d-rgb