Hallins Newton 50 Manual page 196

 It is prohibited for people to be on the platform.
 When the lifting trolley is left unattended, ensure that the wheel brakes are applied, so
as to avoid unintentional movement. The brakes must also be applied if this is required
by the current work task.
 Take care when handling freely suspended loads.
 Do not use the lifting trolley as a jack for vehicle lifting for example.
 The lifting trolley must not come into direct contact with foodstuffs.
 Do not use the lifting trolley in potentially explosive environments.
 When using the lifting trolley in a public environment, especially where children can
come into the working area of the machine, the operator must take adequate measures
to prevent people from entering the risk zone, for example, by cordoning off the work
area, or by fitting the machine with a guard. We recommend that a hazard analysis is
prepared based on the Machinery Directive for the relevant working situation.
 A load must not be present on the load carrier for inspections, service and repairs.
 The lifting trolley's drive unit is located beneath protective housing. This may only be
removed by personnel qualified to carry out inspections, service, and repairs.
 Only Hallins original spare parts may be used when replacing parts. Failure to observe
this may nullify the warranty obligation in full.
 The motor housing and certain other components are made of plastic. They must not be
exposed to flames or corrosive chemicals.
 Handle spent batteries as hazardous waste, and dispose of them at a designated place.
 Observe crushing risk between the load bed and supporting legs, and between load bed
and mast.
 Refer additionally to Signs, Chapter 14. Check regularly to ensure the signs are intact.
9