Using The Remote Controller - Onkyo MD-105X Operating Instructions Manual

Using the remote controller

Inserting the remote controller
batteries
1
Remove the battery compart-
ment cover by opening it as
shown in the illustration.
2
Insert two AA (R6 or UM-3)-size
batteries into the battery com-
partment.
Carefully follow the polarity diagram
(positive(+) and negative (–) symbols) inside
the battery compartment.
3
Replace the compartment cover.
Notes
• Do not mix new batteries with old batteries or
differnt kinds of batteries.
• To avoid corrosion, remove the batteries if the
remote controller is not to be used for a long
time.
• Remove dead batteries immediately to avoid
damage from corrosion. If the remote
controller doesn't operate smoothly, replace
both the batteries at the same time.
• The life of the batteries supplied is about six
months but this will vary depending on usage.
8
Using the remote controller
Point the remote controller toward the remote
control sensor.
With the supplied remote controller
(RC-409MD)
5m
30°
30°
RC-409MD
Point the remote controller toward
MD-105X's remote control sensor.
• Place the unit away from strong light such as
direct sunlight or inverted flourescent light
which can prevent proper operation of the
remote contoroller.
• Using another remote controller of the same
type in the same room or using the unit near
equipment which uses infrared rays may cause
operational interference.
• Do not put any object such as a book on the
remote contoroller. The buttons of the remote
contoroller may be pressed by mistake and
drain the batteries.
• Make sure the audio rack doors do not have
colored glass. Placing the unit behind such
doors may prevent proper remote contoroller
operation.
• If there is any obstacle between the remote
contoroller and the remote control sensor, the
remote controller will not operate.
MD-105X
Remote
control sensor