Table of Contents
Advertisement
Analog recording (continued)
Since the interval between tracks is
detected based on the sound level, some
tracks may not be numbered correctly in
the following cases:
• Recorded condition of the cassette tape
is bad (noise between tracks).
• Low sound level in quiet music.
• Interval between tracks is extremely
shot.
• Tuner's reception is bad (noise).
To disable this function refer to the
explanation below on this page.
To manually record a track number
While recording, press the o REC button when
you wish to mark a track number.
If you wish to mark two or more track numbers
sequentially, provide a sufficient interval
between each press of the o REC button. Too
short (about 4 seconds or less) an interval may
lead to a failure in marking track numbers.
To stop recording temporarily...
Press the s/g button (or the g button on the
remote controller). To resume recording, press
the s/g button (or press the s button on
the remote controller).
To stop recording...
Press the e STOP button.
To eject the MD...
Press the e STOP button, then the r EJECT
button.
Note
If TOC is flashing when you press the r EJECT
button or the STANDBY/ON button, it means the
MD recorder is writing the recorded contents onto
the MD. During this period, do not disconnect the
power cord or apply strong vibrations to the MD
recorder. Doing so may prevent normal recording
onto the MD.
If the MD recorder's power cord is connected to the
SWITCHED service power outlet on the rear panel
of your amplifier, etc., do not turn off the amplifier.
To disable the automatic track numbering
function...
Perform the following steps while you are
recording or waiting for the recording to start:
EDIT/NO
DIGITAL IN
1
L
40
20
10
6
R
1. Press the EDIT/NO button.
"LevelSync?" appears on the display.
2. Press the YES button.
YES
1
DIGITAL IN
L
40
20
10
6
R
If the function is currently turned on.
"On
Off? "appears on the display.
3. Press the YES button.
"LvlSyncOff" appears on the display.
DIGITAL IN
1
L
40
20
10
6
R
Now the tracks will not be numbered during
recording.
• Press the EDIT/NO button any time if you wish
to cancel the setting.
To enable the automatic track numbering
function...
Perform the following steps while you are
recording or waiting for the recording to start:
• Press the EDIT/no button.
"Level Sync?" appears on the display.
• Press the YES button.
If the function is currently turned off,
"Off
On?" appears on the display.
• Press the YES button.
1
2
3
4
5
6
7
8
9 10
2
0
11 12 13 14 15
15
1
2
3
4
5
6
7
8
9 10
2
0
11 12 13 14 15
15
YES
1
2
3
4
5
6
7
8
9 10
2
0
11 12 13 14 15
15
27
Hide quick links:
Advertisement
Table of Contents
