Table of Contents
Advertisement
INSTALLATION
8. Clean up all dust and debris created by drilling and the
installation of the toggle anchors.
9. Plug the female end of the
detachable power cord into
the power inlet on the back
of the unit, near the bottom.
NOTE: If using ethernet to
connect to the internet,
plug the ethernet cable
into the ethernet port
near the power inlet.
10. Being
careful
not
damage the floor, move
the unit back to the
installation location, and line up the holes on the mounting
bracket with the toggle anchors.
11. Insert the included screws through the wall bracket and
into the toggle anchors. Tighen until flush and snug. Do not
overtighten.
Toggle Anchor
Toggle Anchor
Screw
Screw
Anchoring the Unit to A Wall
Finishing Installation of the Pickup Pod
Prepare the Pickup Pod for setup and operation.
1. Install the cellular and WiFI anntennas onto the antenna
plate on top of the unit. The fittings on the plate are labeled.
• Thread the two cellular (mobile) antennas onto the
appropriate fittings until hand tight.
• Thread the two WiFi antennas onto the appropriate
fittings until hand tight.
Installing the Antennas
Ethernet Port
Detachable
Power Cord
to
Wall Anchoring
Wall Anchoring
Bracket
Bracket
Bracket
Bracket
Hex Screw
Hex Screw
Cellular
Fitting
WiFi
Fitting
Antenna
Plate
2. Move the antennas to their
proper positions.
• The cellular (mobile)
antennas
should
positioned at 45° angles,
opposite from each other.
• The WiFi antennas should
be positioned straight up.
3. Plug the male end of the
power cord into a properly
grounded electrical receptacle of the correct voltage, size,
and plug configuration. See the SPECIFICATIONS section
for details.
Setting Up the Pickup Pod for Operation
The final steps in setting up a Pickup Pod for Operation include
registering the Pickup Pod, connecting the Pickup Pod to the
internet, and creating an Admin Account.
Registering a Pickup Pod
For information on how to register a Pickup Pod, access the
link below:
Registering a Pickup Pod
Connecting the Pickup Pod to the Internet
The Pickup Pod must be connected to a cellular or local network
in order to communicate with the Minnow cloud software for
administration and operation.
There are three options for network connection, listed below in
the preferred order:
• Cellular Network—This is the default method and is set up
before the Pickup Pod arrives onsite. Once power is on, the
Pickup Pod will connect automatically to the Minnow cloud
software. Pickup Pods currently use the Verizon 4G cellular
network.
• WiFi—For WiFi connection setup instructions, access the
link below:
Connect Pickup Pod to WiFi
• Ethernet—This is a hardwired
connection and requires an
ethernet cable that connects
the Pickup Pod to a modem/
router. The ethernet port is
located on the back of the
unit, near the power inlet. For
ethernet setup instructions,
access the link below:
Connect Pickup Pod to Ethernet
Creating an Admin Account
For information on how to create a Admin Account, access the
link below:
Creating an Admin Account
8
WiFi
WiFi
Mobile
be
Mobile
Ethernet Port
HPPM-0422
Advertisement
Table of Contents
