Operation - Hatco GLO-RAY GRSS-2418 Installation & Operating Manual

OPERATION

WARNING
Plug unit into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. If the plug and receptacle do not
match, contact a qualified electrician to
determine the proper voltage and size and
install the proper electrical outlet.
CAUTION
Some exterior surfaces on the unit will get hot.
Use caution when touching these areas to avoid
injury.
CAUTION
Unit is not weatherproof. For safe and proper
operation locate the unit indoors where the
ambient air temperature is a minimum of 70°F
(21°C).
Power On/Off Switch
Form No. GRSSM-0106
1. Plug warmer into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. See SPECIFICATIONS for details.
2. Place the Power Switch in the ON position.
See Figure 8.
3. Turn the thermostat to the desired temperature
setting.
4. Allow unit 30 minutes to reach operating
temperature.
Shelf Thermostat
Figure 8. Control Panel
8