Emerson PACSystems RSTi-EP User Manual page 451

User Manual
GFK-2958L
Figure 280
Name
Station
Description
Vendor
Device ID
Model
Hardware Rev.
Class
Software Rev.
4. Enter Name, Description and Station if desired.
5. To add modules to the slave, select the Modules tab and click Add. The Select New
Note:
Commissioning
The name assigned to the slave. You can edit the name or use the default
name. The name appears in the title bar of the dialog box (in the figure above,
the default name is Station 1.
The address of the slave on a PROFIBUS DP network. The slave is defaulted to
the next highest available address.
An optional description for the slave device. The Inspector displays a
maximum of 254 characters. However, more than 254 characters can be
entered in the dialog box.
The manufacturer of the slave device, from the GSD file. This is a read-only
field
The ID of the PROFIBUS device. This is a read-only field.
The model of the slave device. This is a read-only field.
The hardware revision of the device, from the GSD file. This is a read-only field.
The class of the slave device. This is a read-only field.
The software revision of the device, from the GSD file. This is a read-only field.
Module dialog box displays.
To add the slave to the configuration, you must configure at least one module.
Section 8
May 2021
437