Alve Maintenance; Servicing The Venturi - Kinetico Essential Series Technical Manual

V. Valve Maintenance

Servicing the Venturi

1. Remove screws
Remove screws using a 1/4" nut drive
4. Remove venturi
Use small screwdriver to pry venturi out of
plug (insert screwdriver near tab).
7. Push venturi / plug back into valve
Make sure screw holes on plug align with
screw holes on valve.
Technical Manual
2. Twist plug 90˚
5. Snap fit new venturi
Snap fit in after lining up tabs on venturi
with matching holes in plug.
8. Insert screws
Insert screws using a 1/4" nut driver
13
3. Pull out venturi / plug assembly
6. Lubricate O-rings with silicone (3 places)