Setting The Accudial; Manual Regeneration - Kinetico Essential Series Technical Manual

Setting the AccuDial

1. Manually regenerate valve
4. Align arrow to setting

Manual Regeneration

Using a #2 Phillips screwdriver, push down firmly on the softener valve screw
and slowly turn clockwise, listening for four (4) clicks to start the regeneration.
At this point, you should hear water begin to run through the system. If you do
not hear water running through the system, the disc has not been advanced far
enough.
NOTE: The hot water tank has refilled with hard water, it may take several days
for it to empty and for the customer's water to feel soft again.
Essential Series Gold and Platinum
2. Use disc selection chart to determine
setting
Document No. 15825
5. Make sure knob is up after setting
AccuDial
22
3. Adjust AccuDial by pushing and turn-
ing knob