Table of Contents
Advertisement
Preparations Before Use
en
When Using the Stand
Pull out the stand and use it to prop the control unit up on
its side.
Power Supply
When using the AC Adapter
Insert the AC adapter plug into DC jack socket of the control
unit, and plug the AC adapter into a wall socket.
Note
Use only genuine Tanita products.
When using the AC adapter, please use it after removing the
batteries.
When using the batteries
"
" is displayed when battery power is running out. Promptly replace with six new batteries.
Replacing the batteries
1.Loosen the lock screw on the battery compartment in the
control unit to remove the battery compartment.
2.Insert the batteries correctly by aligning them as show,
then tighten the battery compartment lock screw to close.
Prohibited
Note
Approximately 100 hours (when using alkaline dry cell batteries)
12
Do not use old batteries together with new batteries, or a mix of different types of batteries at the
same time.
Doing so may result in malfunction.
Do not replace with wet hands. Do not allow water to contact or spill on the battery compartment.
Doing so may result in malfunction.
(continued)
Advertisement
Table of Contents
