Event Messages - Linx 7900 Food Grade Manual

How To Use the 7900 Food Grade
Printer
8
Continue to remove any ink deposits that remain with the solvent and foam swabs.
Allow the components to dry.
NOTE: Allow a minimum of 10 minutes for the printhead to dry completely before
you start the printer (this may take up to 20 minutes on a cold day). This is
important as the printer may fail on startup if the printhead is not
completely dry.
9
Remove any ink from the inside of the printhead cover tube with Linx food grade
solvent 6600, as shown in Figure 7, and allow to dry.
NOTE: Allow a minimum of 10 minutes for the printhead cover tube to dry
completely before you refit the tube (this may take up to 20 minutes on a
cold day).
10
Refit the printhead into the printhead cover tube and tighten the securing screw.

3.2.1 Event messages

If the printer fails with the following event messages, use the procedure described above to
clean the printhead:
•
2.02 Phase Failure
•
2.03 Time of Flight Failure
•
2.09 Misaligned Ink Jet
If the problem continues, perform a Nozzle Clear or Nozzle Flush sequence. Refer to the
Linx 5900 & 7900 Quick Start Guide for more information.
11
Figure 7. Clean the printhead cover tube
Page 11 of 11
68755
FA69387–2 English
Jun 2013