Inspection And Removal Of The Tamper Detection Tag - Xylem emnet BLU-X Radar B Service Manual

DRAFT – CONFIDENTIAL – NOT FOR DISTRIBUTION
Normally maintenance of the unit involves the following few steps:
1. Removal of the radar and support bar assembly from the sewer

2. Inspection and removal of the tamper detection tag

3. Visual inspection of the external surface of the radar enclosure
4. Opening of the enclosure and inspection of the interior
5. Inspection and replacement of desiccant
6. Inspection and replacement of batteries
Step 1 above should be completed according to support bar service documentation.
Steps 2-6 are addressed below.
11.1 Inspection and removal of the tamper detection tag:
No. Description
Check to make sure the tamper detection tag
is intact. If the tag is broken then please
record and report the issue and use extreme
caution when servicing the unit, as it may
have been tampered with; only authorized
users are allowed to open the unit.
Remove tamper detection tag by snipping it
Illustration
8