Table of Contents
Advertisement
EN
Installation
The unit can be easily moved in the room. In
the moving process, ensure that the it is in the
upright position and it should be placed on a
flat surface.
1.1 Install the vent hose (as shown in fig.1):
screw the vent hose (exhaust fitting end)
into the exhaust port on the rear panel
(counterclockwise).
1.2 Install the window cover plate
1. Half open the window, and mount the
window cover plate to the window (as
shown in fig.2 and fig.3); it can be placed in
horizontal and vertical direction .
2. Pull various components of the window
cover plate open, adjust their opening
distance to bring both ends of the cover
plate into contact with the window frame,
and fix the various components of it.
1.3 Install the unit.
1. Move the unit with installed vent hose
and fittings before the window and
the distance between the unit and walls
or other objects shall be least 50 cm (as
shown in fig.4).
2. Elongate the vent hose and snap the flat
end of the vent hose joints into the elliptical
hole of the window cover plate (as shown in
fig.5 and fig.6) .
Notes:
•
The flat end of the vent hose joints
must be snapped into place.
•
The hose cannot be distorted nor
has substantial turning (greater than
45 °). Keep the ventilation of the vent
hose unobstructed.
Important Notice
The length of the vent hose shall be
280~1,500 mm, and this length is
based on the specifications of the AC. Do
not use extension tubes or replace it with
other different hoses, or this may cause a
malfunction. Exhaust must be unobstructed;
otherwise it may cause overheating.
4
Climobile
j
••
Fig.2
Fig.5
Fig.1
Fig.3
Fig.4
Fig.6
Advertisement
Table of Contents
