Page 2
PA2200C Introduktionssidorna består huvudsakligen av bilder. För översättning av de engelska texter som används, se respektive språksidor. The introduction pages consist mainly of pictures. For translation of the English texts used, see the respective language pages. Introduksjonssidene består hovedsakelig av bilder. For oversettelse av de engelske tekstene, se de respektive språksidene.
Page 3
PA2200C PA2200C 1026 / 1536 / 2026 1050 / 1560 / 2050 90,5 min 500 Cu ø15 min 500 min 500 min 500 min 500 Fig. 1 Gland Gland ø17,5 ø17,5 Knock-out ø32,5 Knock-out ø25,5 Gland ø20,5 Knock-out ø17,5 Fig. 2...
Page 10
PA2200C PA2210CE03 / PA2210CE05 0 -10V N H1H2 N F1 F2 F3...
Page 11
PA2200C PA2215CE08 / PA2220CE10 0 -10V N H1H2 N F1 F2 F3...
Page 12
PA2200C PA2210CE08 / PA2215CE12 / PA2220CE16 0 -10V N H1H2 N F1 F2 F3...
Page 13
PA2200C PA2210CW / PA2215CW / PA2220CW 0 -10V N H1H2 N F1 F2 F3...
Page 14
PA2200C PA2210CE05YD / PA2215CE08YD 0 -10V N H1H2 N F1 F2 F3...
Page 15
PA2200C PA2220CE10YD 0 -10V N H1H2 N F1 F2 F3...
Page 16
PA2200C PAMLK, motor alarm card 0 -10V N H1H2 N F1 F2 F3 N F1 F2 F3...
Page 17
PA2200C Output charts water Supply water temperature:110 °C Water temperature: 110/80 °C Room temperature: +18 °C Room temperature: +18 °C Outlet air temperature: +35 °C* Type Airflow Output Return Water Pressure Output * Outlet Water Pressure position water temp. flow drop air temp.
Page 18
27,9 0,04 2400 45,2 0,22 12,8 25,4 0,07 PA2220CW 1400 38,9 0,08 27,1 0,05 ) Recommended outlet air temperature for good comfort and optimized output. ) Nominal output at given supply and return water temperature. See www.frico.se for additional calculations.
Page 19
PA2200C Assembly and operating instructions General Instructions Mounting with wall brackets (fig. 6) Read these instructions carefully before 1. Mount the brackets on the wall, see fig.6A installation and use. Keep this manual for and dimension drawing fig.1. If the wall is future reference.
Page 20
Note that the unit shall be preceded by a the screws on the top of the unit and then regulating valve, see Frico valve kit. detach the bent edge at the bottom. (Fig.3) The water coil is connected on the upper 3.
PA2200C Maintenance Temperature control Unit with water heating See control pages. The appliance filter should be cleaned Replacing motor or impeller regularly to ensure the air curtain effect and 1. Remove gable end. the heat emission from the device. How often 2.
Page 22
PA2200C For units with water coil, also check the follo- Safety wing: • For all installations of electrically heated • That the water coil is air free. products should a residual current circuit • That there is enough water flow. breaker 300 mA for fire protection be used.
Page 23
PA2200C Controls The air curtain has an integrated control system and can be remotely controlled. 230V~ Actuator SD230 Black (remove the quick Brown connector) Blue PA2DR (accessory) External on/off Eg time switch. External potential free closure = off Factory setting dip-switches - Unit without heating Factory setting dip-switches - Unit with water or with electrical heating heating...
PA2200C Fan step 1/2/3 ~20 °C Heat step Electric: Half/full power Water: On/off (1 LED) On/off Control panel - Unit with electrical heating or water heating Fan step 1/2/3 On/off Control panel - Unit without heating Remote control - on/off, fan steps and heating steps Functional test Temperature control Functional test is started using the remote...
Page 25
Main offi ce Frico AB Tel: +46 31 336 86 00 Box 102 SE-433 22 Partille mailbox@frico.se Sweden www.frico.se For latest updated information and information about your local contact: www.frico.se...
Need help?
Do you have a question about the PA2210CA and is the answer not in the manual?
Questions and answers