Table of Contents
Advertisement
1 DESCRIPTION AND OPERATION
DEVICE DESCRIPTION
The device M-BUS-2 is designed for reading of values from metering instruments via M-
BUS interface and further accumulating and transmitting of this data to the LoRaWAN
The converter is powered by a 6400 mAh built-in battery.
Converter M-BUS may operate in the independent poll mode of the metering devices
converter only with the next supported devices:
• Heat meter «Teplouchet-1»
• Heat meter «STE 21 «Berill»
• Heat meter «ELF-M Teplovodomer»
• Heat meter Landis Gyr T230
• Heat meter Sharky 775
• Heat meter Pulsar
• Heat meter Calec ST II
• Heat meter Calec ST II_2
• Heat meter Sensonic II
• Heat calculator ZENNER_MULTIDATA_WR3
• Heat meter "Pulse STK-15"
• Heat meter "Hiterm PUTM-1"
The list of supported metering devices depends on the firmware version, therefore, the
issue of support for a specific device should be specified when ordering.
Starting with firmware 2.0 and higher, different types of metering devices
can be connected to one converter
The converter is configured via USB using the special «Vega LoRaWAN Configurator»
software.
WORK ALGORITHM
Vega M-BUS-2 operates in the following modes:
«Storage» — it is a mode for storage and transportation. In this mode, the device does
not regularly transmit data to the network.
«Active» - device operating mode.
Before starting to use the converter, it is necessary to take out of the «Storage» mode.
4
M-BUS-2 / User Manual
network.
®
Revision 10 - 13.10.2021
Advertisement
Table of Contents
