Toshiba RAV-GP561ATW-E Service Manual page 103

RAV-GP801ATW*
(1) DN setting the jumper wires and DIP switches
Part name
Jumper wire J800 ~ J804
J805 ~ J807
Model switching (J800 to J804)
Since this service P.C. board is available for several models, cut the jumper wires according to the following table.
If they are not cut correctly, a check code "L10" or "L29" appears on the remote controller and the operation of the
air conditioner is disabled.
Model name
Factory setting (default)
RAV-GP801ATW*
*: Characters indicate the country code (-E), (-TR), and etc.
(Example: RAV-GP801ATW-E)
(2) Installing the P.C. board
(1) Please remove below parts in the following order.
screw A (4p),
(2) Please remove the following parts from the P.C. board, and attach them to a Service P.C. board.
ZCAT2132-1130 (1p),
(3) Apply thermal grease to SUB-HEATSINK of Service P.C. board.
(4) After installing Service P.C. board and HEATSINK, Attach the removed parts and tighten by screws.
(5) Connect the lead wires according to the wiring diagram stuck on the backside of the panel.
(6) About the model of No. 01, Insert the connector of fan motor into CN300. (Don't use CN400).
About the model of No. 02 - 03, insert the connector of the upper fan motor into CN400,
Insert the connector of the lower fan motor into CN300.
screw A
CN400
COVER
CN300
ZCAT2132-1130
TUBE
screw A
ZCAT2032-0930
attach it to both (A) lead wire and (B) lead wire together.
(A) lead wire: The wire connect P-22 and P-23.
(B) lead wire: The wire from CN-21 to Reactor.
Function
Model switching
Settings
J800 J801 J802
O O O
×
O O
COVER, screw B (3p),
ZCAT2032-0930 (2p),
FUSE-COVER
HEATSINK
SUB-
HEATSINK
ZCAT2032-0930
Cut these jumper wires according to the following table.
Set these jumper wires same as the settings of the P.C. board before
replacement.
J803 J804
O O
O O
×
O: Connected, : Cut
HEATSINK
TUBE, FUSE-COVER,
screw B
SPACER
103
Setting
J804, J805, J806, J807
J800, J801, J802, J803
SPACER
Apply thermal grease
Between SUB-HEATSINK
and HEATSINK.