NordicTrack VAULT User Manual page 9

5. See the inset drawing. Locate the Screw
Bushing (18) at the bottom of the Hinge (7).
Apply a generous amount of grease to the Screw
Bushing.
Next, slide the Lower Bracket (16) onto the
bottom of the Hinge (7) as shown and hold it in
place.
Then, attach the Lower Bracket (16) to the
Door (3) with four M4 x 12mm Screws (32); start
all the Screws, and then tighten them.
Next, plug the Hinge Wire (21) into the receptacle
in the back of the Door (3).
See assembly step 4. Tighten the M8 x 15mm
Screw (31) enough that you can open and close
the Door (3) easily, but the Door does not move
on its own when it is at rest.
6. With the help of a second person, move the
fitness mirror to the location where it will be
used.
Secure the fitness mirror to a wall stud with the
included Tether (19) as described below.
Attach the Tether (19) to the back of the Cabinet
(1) with two M6 x 10mm Screws (34).
Next, attach the bracket on the other end of the
Tether (19) to a wall stud with two M5 x 50mm
Lag Screws (35). Then, tighten the Tether to the
appropriate length.
5
21
3
7
16
6
9
7
18
Grease
16
32
1
19
34
35