NordicTrack VAULT User Manual page 8

3. Tip: Avoid damaging the mirror. With the help
of a second person, orient the Door (3) so that
the speakers (C) are at the bottom.
Have a second person hold the Door (3) until
you complete assembly step 5.
See the inset drawing. Identify the Upper
Bracket (15) and the Lower Bracket (16).
Attach the Upper Bracket (15) to the back of the
Door (3) with four M4 x 12mm Screws (32); start
all the Screws, and then tighten them.
4. Locate the Pin Bushing (25) in the Upper
Bracket (15).
Using a plastic bag to keep your fingers clean,
apply a generous amount of the included grease
to the Pin Bushing (25).
Tip: Avoid pinching the Hinge Wire (21) and
avoid damaging the mirror. With the help of a
second person, hang the Upper Bracket (15) on
the top of the Hinge (7).
Then, tighten the M8 x 15mm Screw (31) a few
turns into the Upper Bracket (15); do not fully
tighten the Screw.
3
C
4
15
31
25
Grease
21
7
8
15
16
Avoid damaging
the mirror
3
15
32
Avoid pinching
the Hinge Wire
(21) and avoid
damaging the
mirror