Connect The Debugger - Wiznet W7100A Manual

2 Connect the Debugger

This section will explain how the Debugger is connected with iMCU7100EVB. Connect the
Debugger to the DTAG of IMCU7100EVB.
USB
Connect the other DTAG cable between the Debugger and iMCU7100EVB.
DTAG cable must be connected to line number 1 of iMCU7100A DTAG socket.
USB cable between the Debugger and PC. Next, insert the power cable to the IMCU7100EVB,
and push the EVB reset button as figure 2.1. Then, push the debugger reset button of the
Debugger. Confirm the LED5 (RUN LED) after pushing these reset button.
© Copyright 2012 WIZnet Co., Inc. All rights reserved.
DTAG
Reset
[Fig.2.2] iMCU7100EVB
Reset Button
[Fig.2.2] W7100A / W7100 Debugger
LED5
DTAG
The red line of
Also connect the
Ver. 1.1
5