Wiznet W7100A Manual page 17

Board reset only
The Board reset command only is used to reset the board only. If breakpoints were set, they
will be maintained. To reset the board, click the
'Debug menu' => 'Board reset'. It can also be done by short key F2.
Image load
The Image load command is used to load an image.
Write the HEX image for debugging to the Flash memory.
Click the button or select Debug menu => Image Load menu to execute 'Image Load.'
It can also be done by short key F3.
If the image writing and verifying is successful, 'Write OK' message will show.
Note: If there is a mismatch between the board image file and present HEX file, the error
message is shown when execute the 'Debugger commands' such as 'Continue, Step, Next'.
Debugging
The W7100A / W7100 Debugger serves 'Debug' and 'Tool' menu and Toolbar button for
debugging.
Go to Source Line
The Go to Source Line command is used to move the cursor to the wanted source line. To use this
function, select the 'Tool' menu => 'Go to Source Line' or use short key Ctrl + G.
Find
The Find command is used to find some words on the source window. To use this function, select the
'Tool' menu => 'Find' or use short key Ctrl + F.
© Copyright 2012 WIZnet Co., Inc. All rights reserved.
[Fig.5.6] Load image mismatch
[Fig.5.7] Deugging menu
button of the toolbar or select the
Ver. 1.1
17