Wiznet W7100A Manual page 19

Table of Contents

Advertisement

Nexti
The Nexti command executes one instruction. But the command does not enter into the related
Function even if the instruction is a Function call. After its execution, the debugger is stopped and waits
for next command.
To use this command click the
It can also be done by short key F6.
Run to cursor line
The 'Run to cursor line' command executes the code until the cursor on the debugger source window is
met.
To use this command, select the push the mouse right button => select 'Run To Cursor Line(n)' or
select the Debug Menu => Run To Cursor Line.
Sometimes the 'Run To Cursor Line' command continues when the cursor is not properly set.
If that is the case, execute the Stop command to stop it.
© Copyright 2012 WIZnet Co., Inc. All rights reserved.
button or select the Debug menu => Nexti.
[Fig.5.8] Run To Cursor Line command
Ver. 1.1
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

W7100

Table of Contents