1 Driver installation for the Debugger
Connect the Debugger and PC with USB cable, and then the 'new hardware search window' will open
as figure 1.1 below.
Select 'Automatically setup the software (I)' and click the Next (N) button.
If it is not automatically installed, select the 'Install from a list or specific location (Advanced) and set
our attached driver as below.
Wait for searching the device driver of the Debugger. When the device driver installation is completed,
© Copyright 2012 WIZnet Co., Inc. All rights reserved.
[Fig.1.1] The new hardware search window 1
[Fig.1.2] The new hardware search window 2
Ver. 1.1
3