A5 - Active Alarm - Graco G5-G-24PR-4L0L05-00C00000 Manual

Fault, and Low Level LED illuminate.
HH MM
ON
MM : SS
F . 23
IG
NOTE: When programming a time of less than 10 min-
utes a leading zero must be programmed in the first
number field and then press the ENTER button to save
the zero selection.
1. To set the time use the UP or
DOWN ARROW button to
scroll through numerals 0 to
9 until the desired number
appears in the first MM (min-
utes) field.
2. Press the ENTER button to lock in the
selection. The next MM number field to
the right flashes indicating it is ready for
programming.
3. Use the UP or DOWN
ARROW button to scroll
through numerals 0 to 9 until
the desired number appears
in the second MM number
field.
4. Press the ENTER button to lock in the
selection.
The next number field to the right
flashes and the LED lights under SS; indicating it is
ready to program the seconds fields.
3A8848A
SS ##
!
OFF
HH : MM
5. Repeat steps 1 - 4 to set the SS (seconds) fields.
6. After pressing the ENTER button to set
the last SS field, all the programmed ON
Time information is saved.
Unit exits Advanced Programming.

A5 - Active Alarm

Changes the alarm output behavior. Uses output to
determine if a fault has occurred.
Fault and ON LED's illuminate.
HH MM SS
ON
MM : SS
C
1
P
C
C
2
P
C
P
3
P
F . 24
IG
1. The default OFF dis-
plays.
2. Press the UP or DOWN
ARROW button to change
OFF to ON on the display to
activate alarm condition.
3. Press the ENTER button to exit
Advanced Programming.
Advanced Programming
##
!
OFF
HH : MM
1 2 3
33