List Of Symbols Used - Lode Valiant 2 Rehab Manual

1. If your device has an RS232 or USB port, connect it directly to the PC LEM is installed on. If your
device has a RJ45 connector plug it with an UTP cable to the special interface connector that was
delivered with your device and to a USB port in your PC.
2. Start Lode Ergometry Manager on your PC
3. If your device has a control unit, select "Terminal"- mode to allow external command. If your device
does not have a control unit the terminal mode is automatically selected. (See for detailed instructions
the user manual of LEM).

12 - List of symbols used

Network (Proprietary Lode)
External Control Connector
Emergency Stop
the footrail while lowering.
Read manufacturer's guide, advises and instructions and manual
On-off Switch
The equipment has a safety earth (ground) connection and must be connected to an
earthed (grounded) wall socket.
Tested and certified to U.S. and Canadian National Standards by a NRTL, viz
TÜV Rheinland. Compliance for U.S. and Canadian markets.
M938901/938903_MANUAL VALIANT 2 REHAB (XL) / VERSION: V1.1 - 2016-08-25
Trapping zone. Warning: do not jump onto the rotating belt. Do not jump
off the rotating belt (not even to the front). Do not stop moving on the
running belt. Do not turn around on the running belt. Do not move
sideways or backwards. Do not make movement that could get you out
of balance. Keep away from rollers. The operator must keep away from
13/22