Cleaning - Lode Valiant 2 Rehab Manual

2km/h so you can timely intervene is the belt goes to one side quickly.
To finalize the alignment procedure set the treadmill to maximum speed for 2 minutes and check the
alignment of the belt.
Note: NEVER use any lubricants on the walking belt. The belt is self greasing using a wax layer that will
dispose on the deck on high friction points and on higher speeds. The belt does not need to be re-
waxed and runs the complete lifetime of aproximately 10.000km. Incorrect tension, alignment and/or
use can decrease the lifetime of the belt.

9 - Cleaning

The belt can be cleaned with a sponge, with little lukewarm water. Allow the belt to dry thoroughly
after cleaning before re-using the treadmill.
M938901/938903_MANUAL VALIANT 2 REHAB (XL) / VERSION: V1.1 - 2016-08-25
Now start the treadmill with a
speed of 2 km/h. Make
corrections with the allen tool
to the belt alignment so the
edge of the belt stays in the
middle of the hole.
When the belt is properly
aligned you may repeat the
above procedure on higher
speeds. But be cautious; higher
speeds will have a faster
implementation of the belt
alignment when turning the
allen key. Always start with the
11/22