Panasonic PAN9028 Integration Manual page 27


PAN9028 Bluetooth/Wi-Fi Module
8.1.3 Label Requirements
The following labelling requirements have to be implemented on the OEM end product:
The OEM must ensure that FCC labelling requirements are met. This includes
a clearly visible label (laser marking) on the outside of the OEM enclosure
specifying the appropriate Panasonic FCC identifier for this product as well as
the FCC notice above.
The FCC identifier is FCC ID: T7V9028.
This FCC identifier is valid for the PAN9028.
The end product must in any case be labelled on the exterior with:
"Contains FCC ID: T7V9028".
Due to the PAN9028 model size, the FCC identifier is displayed in the installation instruction
only and it cannot be displayed readable on the module's label due to the limited size.
8.1.4 Antenna Warning
The following antenna has to be followed by the OEM:
This antenna warning refers to the test device with the model number ENWF9408A1EF and
ENWF9408A2EF in bottom pad mode (see "PAN9028 Product Specification"
Information.)
The device is tested with a standard SMA connector and with the antenna listed below. When
integrated into the OEM's product, these fixed antennas require installation preventing end
users from replacing them with non-approved antennas. Any antenna not in the following table
must be tested to comply with FCC Section 15.203 for unique antenna connectors and with
Section 15.247 for emissions. The FCC identifier for the device with the antenna listed in
 8.1.5 Approved Antenna List
Module Integration Guide Rev. 1.0
8 Regulatory and Certification Information
is the same (FCC ID: T7V9028).
 9.2 Product
Page 27 of 34