Installation; Setting Up The Screen; Screws Tightening Torques; Preparing The Attachment Plate - Panasonic ET-PKR100P Installation Instructions Manual

Table of Contents

Advertisement

Installation

After checking the height, width, and structure of the installation location while referring to "Standard installation
dimensions" on pages 6 to 8, determine the appropriate positions for setting up the screen and installing
the projector.

Setting up the screen

Set up the screen according to the specified method in a position which takes into account the projection distance
and angle and the type of screen being used.

Screws tightening torques

M4 ......... 1.25±0.2 N•m
M6 ......... 4±0.5 N•m
M8 ......... 10±1 N•m
M10 ....... 20±1 N•m
z Use a torque screwdriver or torque wrench to tighten screws and bolts to their specified tightening torques. Do
not use electric screwdrivers or impact screwdrivers.

Preparing the attachment plate

Before installing the attachment plate on the ceiling, attach the pole brace, adjustment poles, and the pole base
to the attachment plate with the following procedures.
■ Attaching the pole brace and the adjustment pole 1 to the attachment plate
Attachment plate
To the screen
Pole brace
(Front)
M6 Hex nuts
M6 Flat washers
1) Insert the pole brace into the center of the attachment
Circular hole
Adjustment pole 1
2) Insert the adjustment pole 1 into the pole brace,
"FRONT"
inscription
3) Insert the supplied two captive washer hex head
(M6 × 16)
(M6 × 80)
z Be sure to tighten the screws to a value within their
plate, and secure the pole brace with the supplied
six captive washer hex head bolts (M6 × 16). (Refer
to the figure on the left for the directions of the
attachment plate and the pole brace.)
aligning them so that the "FRONT" inscription faces
the front.
bolts (M6×80) through the side of the pole brace, and
secure them with M6 flat washers and M6 hex head
nuts. Attach the supplied two captive washer hex
head bolts (M6 × 16) from the screen side of the pole
brace, and secure the pole brace and the adjustment
pole 1.
Attention
specified torque range. If the screws are tightened
with insufficient torque the projected image may tilt.
ENGLISH - 9

Advertisement

Table of Contents
loading

Table of Contents