Table of Contents
Advertisement
Installation (continued)
■ Attaching the pole base to the adjustment pole 2
Adjustment pole 2
"FRONT"
inscription
Arrow
(M6 × 80)
■ Attaching the angle adjusting bracket to the pole base
Arrow
■ Joining the adjustment poles 1 and 2
Adjustment pole 2
Adjustment pole 1
10 - ENGLISH
1) Place a pole base over the adjustment pole 2 as
(M6 × 16)
2) Insert 2 supplied captive washer hex head bolts
Pole base
Attach the angle adjusting bracket to the pole base,
aligning the arrow mark as illustrated on the left, and
secure them with the four supplied captive washer hex
Pole base
head bolts (M6 × 16).
z First secure the circular holes on the arrow mark side.
Attention
z After adjusting the installation angle on pages 18 to
19, securely tighten the captive washer hex head
bolt of the angle adjusting bracket in four places at the
front and rear.
Angle adjusting bracket
Insert the adjustment pole 1 into the adjustment pole 2,
align the holes, and secure them with the supplied six
captive washer hex head bolts (M6 × 16).
z Align the "FRONT" inscription on the adjustment pole
Arrow
1 with the arrow on the pole base.
z After inserting all 6 bolts into the holes, firmly tighten
"FRONT"
inscription
each one.
Note
z Adjustable screw holes are provided on adjustment
pole 1 at 60 mm (2-3/8") intervals and adjustment pole
2 at 120 mm (4-3/4") intervals. Join the poles to each
other by fitting the adjustable screw holes based on
the projection distance (949 - 1 429 mm (37-3/8" - 56-
1/4")) on page 6.
shown on the left and align the "FRONT" inscription
with the arrow.
(M6
× 80) from the side with the arrow on the pole
base, and fix both using an M6 hex head bolt and an
M6 flat washer. Also attach 2 supplied captive washer
hex head bolts (M6 × 16) to the pole base and firmly
fix the adjustment pole 2.
Advertisement
Table of Contents
