Advertisement
Precautions for installation
Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of improper
installation or operation inconsistent with this documentation.
Installation area for this product
Consult the dealer about the installation area to select a
strong wall area.
• Screws used for installing this product on a wall are not
supplied. Prepare them according to the material and
strength of the area where the product is to be installed.
Recommended screw*: M10 x 4 pcs.
Minimum pull-out strength (per 1 pc.): 823 N {185 lbf}
*When using "M8" screws for reinstallation, make sure
to prepare 4 plain washers and use them together.
• Do not mount the product on a plaster board or a
wooden section because they are too weak. If the prod-
uct is unavoidably mounted on such a section, the sec-
tion shall be sufficiently reinforced.
Take notice of humidity.
Install this product when the humidity is low. If installation is
performed when it is raining or in very humid conditions, the
inside may be affected by humidity, causing mist-over inside
the Camera.
Mounting method for this product
This product is designed to be used as a pendant mount
camera. If the product is mounted on a desktop or at a slant,
it may not work correctly and its lifetime may be shortened.
Protection from lightning
When cables are used outdoors, there is a chance that they
may be affected by lightning. In such a case, install a light-
ning arrestor close to the camera, and make the length of
the network cable between the camera and lightning arres-
tor as short as possible to prevent the camera from being
damaged by lightning.
Do not place this product in the following places:
• Locations where a chemical agent is used such as a
swimming pool
• Locations subject to moisture or oil smoke such as a
kitchen
• Locations that have a specific environment that is sub-
ject to an inflammable atmosphere or solvents
• Locations where radiation, x-ray, intense radio wave, or
strong magnetism is produced
• Locations near coasts directly subjected to sea
breezes, or locations subject to corrosive gases such as
from hot springs, volcanic regions, etc.
• Locations where the temperature is not within the spec-
ified range (The ambient operating temperature of the
installed camera.)
• Locations subject to vibrations, such as on vehicles,
marine vessels, or above product lines (This product is
not designed for onvehicle use.)
• Locations subject to condensation as the result of severe
changes in temperature (In case of installing the product
in such locations, the inside of camera may become
foggy or condensation may be caused in the camera.)
4
Screw tightening
• The screws and bolts must be tightened with an appro-
priate tightening torque according to the material and
strength of the installation area.
• Do not use an impact driver. Use of an impact driver
may damage the screws or cause tightening exces-
sively.
• When a screw is tightened, make the screw at a right
angle to the surface. After tightening the screws or
bolts, perform checks to ensure that the tightening is
sufficient enough so that there is no movement or
looseness.
The protection cover attached to the camera unit
shall be removed after completion of the installation.
(rain wash coating model)
Make sure to remove this product if it will no longer
be used.
Advertisement
