Pc And Device Network Segment Detection; Adding The Ip Address (Windows7 Used As An Example) - ZLG CANSwitch-AN2S2 User Manual

CANSwitch-AN2S2
High-Performance Dual-CAN to Ethernet Switch User Manual
Figure 3.4 Searching for devices by using the ZNetCom software

4.2.3 PC and Device Network Segment Detection

Before using the PC to communicate with the CANSwitch-AN2S2 device, ensure that
there is an Ethernet card in the PC, and the PC and the CANSwitch-AN2S2 device must
be on the same network segment.
The CANE device is set with a default IP address (192.168.0.178) and network mask
(255.255.255.0) when it leaves the factory. Check whether the device is on the same
network segment as the user's PC according to the process shown in Figure 4.5. If you
are on the same network segment, you do not need to read the following content about
the PC network settings. If different, the following PC network settings are very important
for you.
Figure 4.5 Checking whether the IP address of the CANSwitch-AN2S2
device and the PC are on the same network segment
The following describes how to make the user's PC and CANSwitch-AN2S2 device
be on the same network segment.
If you are using Windows 2000/XP/7, there are two ways. One is to add the local IP
address, and the other is to modify the local IP address.

4.2.4 Adding the IP Address (Windows7 Used as an Example)

It is assumed that the IP address of the user's PC is 192.168.7.91, and the IP address
of the CANSwitch-AN2S2 device is the default IP address 192.168.0.178.
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
22
User Manual