Table of Contents
Advertisement
CANSwitch-AN2S2
High-Performance Dual-CAN to Ethernet Switch User Manual
3. Quick Use in Hub Mode (Hub Mode)
Devices in hub mode can implement automatic networking, and devices can be
cascaded in hub mode. This document uses three CANSwitch-AN2S2 devices for
cascading. As long as the device is configured, the CAN bus will be forwarded to the
corresponding CAN port as required. You can network independently without using
switches and other equipment.
3.1 Device Configuration Method
Turn the switch to Hub and press the reset button. After the device beeps twice, it
enters Hub mode. For details, see Section 2.4.
3.1.1 Configuring the Device Using the Serial Port
CANSwitch-AN2S2 supports using the serial port to configure the device, as shown in
Figure 3.1. The device can be configured as long as the dedicated RS232 configuration
port is connected to the PC.
3.1.2 Configuring the Device Using the Network Port
CANSwitch-AN2S2 supports configuration using the LAN port. Just connect one of
the network ports to the PC, as shown in Figure 3.2.
3.2 System Block Diagram
This document uses three devices for cascading and meets the following design
requirements. The CAN signal sent by user equipment 1 and user equipment 2 can be
received by user equipment 3, user equipment 6 and user equipment 7; the CAN signal
sent by user equipment 3 can be received by user equipment 4 and user equipment 5; the
CAN signals sent by user equipment 4 and user equipment 5 can be received by all the
equipment; the CAN signal sent by user equipment 6 can be received by user equipment
1, the user equipment 2, the user equipment 3 and the user equipment 7; the CAN signal
sent by user equipment 7 can be received by user equipment 1, user equipment 2, user
Figure 3.1 Dedicated configuration port
Figure 3.2 LAN port
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
10
User Manual
Advertisement
Table of Contents
