Table of Contents
Advertisement
CANSwitch-AN2S2
High-Performance Dual-CAN to Ethernet Switch User Manual
4.3.2 Configuring the CANSwitch-AN2S2 Device
Figure 4.13 shows the configuration in TCP Server mode.
4.3.3 TCP&UDP Software Operation
Install the TCP&UDP test software, as shown in Figure 4.14.
Double-click to run the TCP&UDP software, and click to create a connection, as
shown in Figure 4.15.
Be
sure
modifications
The default password is 88888
The IP address configuration should be
correct, and the PC and the device should be
on the same network segment
Selecting TCP Server mode
The baud rate should be 1000K, which should
be consistent with the CAN device connected
to the CAN0 port.
Filtering is set, only the frame ID sent from the
CAN port to the Ethernet is filtered, and the
frame ID sent from the Ethernet to the CAN
port is not filtered.
Figure 4.13 Configuration in TCP Sever mode
Figure 4.14 TCP&UDP test software
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
27
to
submit
the
configuration
User Manual
Advertisement
Table of Contents
