Table of Contents
Advertisement
FCC RF Radiation Exposure Statement
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, this
device must not be co-located or operating in conjunction with any antenna or transmitter. This
device contains a low power transmitter. When this device is operational, use only with the supplied,
or recommended antenna. Unauthorized antenna, modification, or attachments could damage the
transmitter and may violate FCC regulations. Changes or modifications not expressly approved by
the manufacturer or party responsible for compliance could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates and radiates radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. There is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio/TV technician for assistance
"This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device"
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de license. L'exploitation est autorisee aux deux conditions suivantes: (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit acceptor tout brouillage
radioelectrique subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement.
RB8762CMF Designer's Guide (RRD2Z50-20180802001-A07-C3)
FCC Interference Statement
IC (Industry Canada) Statement:
.
27
Advertisement
Table of Contents
