Table of Contents
Advertisement
Operating RB8762CMF-D
Introduction:
Radicom provides RTL8762CMF Development Kit as a quick platform for testing. Each
RTL8762CMF DONGLE has an USB connector interface.
If you use USB interface to transmit your data, please plug one USB cable to USB connector and
insert a 4piece jumper into J13 (as below). This USB connector can work as power supply and data
transmission at the same time. With USB interface, you may use
AT-command
(at-i) to check
information of RTL8762CMF dongle
After above connection, you can issue AT commands to instruct the modules to establish a Bluetooth
connection to transmit and receive data through this USB-UART interface.
※The actual data transportation is USB to UART Bridge Virtual COM Port for this usage.
Please download FT232 USB driver from below link:
http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx
RB8762CMF Designer's Guide (RRD2Z50-20180802001-A07-C3)
14
Advertisement
Table of Contents
