Table of Contents
Advertisement
Hardware Set-up - To provide power to the RB8762CMF-MB, plug one end of the USB cable into
USB connector on the RB8762CMF-MB. Plug the other end into the PC USB port.
Pending
PC Set-up - Turn on the PC. To send the AT commands and transmit & receive data with the
RB8762CMF-MB use a serial communication package such as Docklight. Set the appropriate COM
port for each side with the DTE speed set to 9600 and parity set to 8N1.
Docklight setting is as follows:
Step 1. Click upper-right corner of Docklight (as below) to enter "Project Settings".
Step 2. Enter "Project Settings" and choose the appropriate COM port. Then set "COM Port
Settings" as: Baud rate: 9600, 8 data bits, None parity, 1 stop bits and None flow control.
Click "OK" to complete setting.
RB8762CMF Designer's Guide (RRD2Z50-20180802001-A07-C3)
15
Advertisement
Table of Contents
