Table of Contents
Advertisement
Host (End Product) Labeling Requirements
To maintain compliance, the end product hosting the module must be properly labeled to
identify that this module is installed. The final end product must have a label located in a
visible area with the following information:
XXXXXXX is for the model of the module used in the end equipment. The XXXXXXX will
be RB8762CMF, RB8762CMF-HM. The label shall be securely affixed to a permanently
attached part of the device, in a location where it is visible or easily accessible to the user,
and shall not be readily detachable. The label shall be sufficiently durable to remain fully
legible and intact on the device in all normal conditions of use throughout the device's
expected lifetime. These requirements may be met either by a separate label or nameplate
permanently attached to the device or by permanently imprinting or impressing the label
directly onto the device. The label text shall be legible without the aid of magnification, but
is not required to be larger than 8-point font size.
End User Information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF
Exposure compliance. The end user should NOT be provided any instructions on how to
remove or install the device. The user's manual for end users must include the following
information in a prominent location.
RB8762CMF Designer's Guide (RRD2Z50-20180802001-A07-C3)
Contains Transmitter Module
Model: XXXXXXX
FCC ID: K7TRB8762CMF
IC: 2377ARB8762CMF
26
Advertisement
Table of Contents
