Garmin Volvo Penta Glass Cockpit B7 Owner's Manual page 71

Gauges and Graphs
The gauges and graphs provide various information about
the engine and environment. To view the information, a
compatible transducer or sensor must be connected to
the network.
Viewing the Gauges
1 Select A/V, Gauges, Controls.
2 Select a gauge.
3 Select or to view a different gauge page.
Changing the Data Shown in a Gauge
1 From a gauges screen, hold a gauge.
2 Select Replace Data.
3 Select a data type.
4 Select the data to display.
Customizing Engine Gauge and Fuel Gauge Limits
You can configure the upper and lower limits and the
range of desired standard operation of a gauge.
NOTE: Not all options are available for all gauges.
1 From an applicable gauges screen, select Menu > Set
Gauge Limits.
2 Select a gauge to customize.
3 Select an option:
• To set the minimum value of the standard operating
range, select Rated Min..
• To set the maximum value of the standard operating
range, select Rated Max..
• To set the lower limit of the gauge lower than the
rated minimum, select Scale Min..
• To set the upper limit of the gauge higher than the
rated maximum, select Scale Max..
4 Select the limit value.
5 Repeat steps 4 and 5 to set additional gauge limits.
Configuring the Tank Level Sensors
You must connect fuel sensors to inputs 1, 2, 3, or 4.
1 Select Settings > My Vessel > Seven Marine
Installation > Tank Preset.
2 Select a tank level sensor to configure.
3 Select Name, enter a name, and select Done.
4 Select Type, and select the type of sensor.
5 Select Style, and select the style of sensor.
Gauges and Graphs
NOTICE
6 Select Tank Capacity, enter the capacity of the tank,
and select Done.
7 Select Calibration, and follow the on-screen
instructions to calibrate the tank levels.
If you do not calibrate the tank levels, the system uses
default settings for the tank levels.
Mercury Engine Gauges
®
NOTE: This feature is available only when connected to
the Mercury SmartCraft Connect gateway.
Select A/V, Gauges, Controls > Mercury to view the
Mercury engine gauges. This screen varies based on the
engine network.
Engine voltage
Boat status
Boat speed
Fuel
Transmission gear
Engine speed
Trim tabs
Engine trim
Setting the Fuel Alarm
You can set an alarm to sound when the total amount of
remaining onboard fuel reaches the level you specify.
1 Select Settings > Alarms > Fuel.
2 If necessary, select a driveline.
3 Select On.
4 Enter the remaining amount of fuel that triggers the
alarm.
5 If necessary, repeat steps 2–4 for all drivelines.
Viewing Graphs
Before you can view graphs of various environmental
changes, such as temperature, depth, and wind, you must
59