Maintenance; General Notes On Maintenance; Doing A Maintenance Run - PI M-687.UN User Manual

7 Maintenance

7 Maintenance
In this Chapter

General Notes on Maintenance ................................................................................................... 31

Doing a Maintenance Run............................................................................................................ 31

Cleaning the M-687.UN ............................................................................................................... 32
7.1 General Notes on Maintenance
NOTICE
Damage due to improper maintenance!
Improper maintenance can result in the failure of the M-687.UN.
 Loosen screws only when instructed in this manual.
 Make sure that the piezo motors of the M-687.UN do not come into contact with
lubricants.
7.2 Doing a Maintenance Run
Depending on the operating conditions and the period of use of the M-687.UN, the following
maintenance measures are required:
Maintenance run
The maintenance run is done to distribute the existing lubricant on the guides of the M-687.UN.
 To evenly distribute the existing lubricant on the stage guides, do a maintenance run
across the entire travel range after 500 hours of operation, or at least after 1 year.
 If you move the M-687.UN over a small travel range (<20 % of the entire travel range) in
continuous industrial operation, do a maintenance run across the entire travel range
every 5000 motion cycles.
Lubrication
Under laboratory conditions, the guides of the M-687.UN only need to be lubricated in
exceptional cases. For continuous industrial use, the lubrication intervals must be defined
individually.
 Do not lubricate the guides of the M-687.UN without consulting our customer service
department (p. 35).
 Ensure that the piezo motors of the M-687.UN do not come into contact with
lubricants.
M-687.UN XY Stage MP100E Version: 1.3.0 31