Mounting A Positioner On The M-687.Un - PI M-687.UN User Manual

5 Installation
Requirements
 You have read and understood the general notes on installing (p. 15).
 The M-687.UN is not connected to the controller.
Tools and accessories
000031657 screw set (p. 10)

Mounting the M-687.UN onto a surface
1. Move the motion platforms of the M-687.UN by hand until all countersunk holes in the
base body are accessible (refer to illustration above).
2. Fix the M-687.UN with the four M5 screws supplied.
3. Make sure that the screw heads are fully countersunk.
5.4

Mounting a Positioner on the M-687.UN

NOTICE
Impermissibly high load on the XY stage!
An impermissibly high load impairs the motion of the platforms and can damage the XY stage.
 For mounting type and mass of the load, pay attention to the maximum permissible forces
that, according to the specification (p. 37), are allowed to act on the platforms.
NOTICE
Excessively long screws!
The M-687.UN can be damaged by excessively long screws.
 Pay attention to the depth of the mounting holes in the upper platform (p. 40).
 Only use screws of the correct length for the respective mounting holes.
INFORMATION
An adapter plate (p. 10) is mounted on the upper motion platform of the M-687.UN, which
must be removed before mounting certain positioners (e.g., P-736.ZCN2S and P-736.ZRN2S).
Requirements
 You have read and understood the general notes on installing (p. 15).
 The M-687.UN and the positioner to be mounted are not connected to the respective
controller.
M-687.UN XY Stage MP100E Version: 1.3.0 19