Blade Attachment; Installing The Monting Plate - Hinkley TIER 54 Instruction Manual

BLADE ATTACHMENT

Screws

INSTALLING THE MONTING PLATE

Light Wires
Adapter
plate
Screws
Fig. 1
10 | hinkley.com
CAUTION: Remove the two rubber packing mounts from the fan
motor assembly and discard prior to attaching the blades.
Insert the blade through the slot on the housing. Align the holes
on the blade and the fan motor assembly and secure with the
blade support plates and blade attachment screws.
Blades
Blade
support
plates
Mounting Hub
(bottom of motor)
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
NOTE: Be sure the power is off before installing.
Remove one of the three screws on the mounting hub located
1
on the fan motor. Loosen the other 2 screws. (Do not remove)
(Fig. 1)
Pass the light wires through the center hole of the adapter
2
plate.
Place the key holes on the adapter plate over the 2 screws
3
previously loosened, turn the adapter plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.