Blade Attachment - Hinkley 903752FMB-NDD Instruction Manual

BLADE ATTACHMENT

The screws need to be the serrated head screw
10
| hinkley.com
NOTE:
Fasten blade to motor with provided screws, lock washers and at
washers. Repeat procedure for remaining blades. Make sure screws are
TIGHT! Loose motor screws can contribute to unnecessary hum during
operation.
Blades
Screws
Remove any rubber supports that are installed for
shipping.
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large at blade screwdriver
for nal tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.