Panasonic Aquarea WH-ADC0309J3E5 Planning And Installation Manual page 185

!
IMPORTANT
Also follow the following notices to avoid faults and malfunctions of the remote controller:
● Install the cable of the remote controller separately from the cables for the power
supply in order to avoid operating disruptions.
● Mount the remote controller at a distance of at least 1 m from television, radio and
computer devices in order to avoid electrical interference.
● Mount the remote controller vertically on the wall at a height of 1.0 to 1.5 m above the
floor in a position at which the average indoor temperature can be measured.
● To rule out faulty measurements of the indoor temperature, avoid installation locations
with direct sunlight or air draughts, places where the air stream can be diverted or
which are near to a heat source.
● Select an installation location at which the displays can be easily read.
In bi-bloc systems of the J or H Generation, the remote controller is integrated in the indoor unit
(hydrokit or All in One unit) and is hard-wired. It can, however, be dismounted and mounted
separately at any desired location, e.g. even on the wall of a different room than the installation
room of the indoor unit, to serve as a room thermostat.
In mono-bloc systems of the J or H Generation, the remote controller is supplied separately for on-
site installation on the wall.
The cable and assembly material must be field-supplied.
Carry out the following steps to mount the remote controller on the wall and to connect it:
1. For mono-bloc systems: Skip this step and begin wall mounting with step 2.
For bi-bloc systems: First, demount the remote controller from the indoor unit as follows:
a. Open the cabinet of the remote controller (Fig. A), by positioning a slot screw driver (4) or a
similar tool in the slots (3) at the bottom edge and then pry the cabinet top part (1) away from
the cabinet bottom part (2), exercising caution. Take care not to damage the cabinet.
b. Disconnect the electrical wiring of the remote controller (5) from the terminals of the indoor
unit (8) and the remote controller (9) (Fig. B + C).
c. Loosen the three screws (6) from the cover of the connection box to remove the bottom part
of the remote controller (Fig. B).
Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
Installation
6
185