Installation
Hydrokit J or H Generation
Carry out the following steps to connect the drain hose to the safety valve drainage tap of the
hydrokit:
6
174
1. Slide the drain hose onto the safety valve drainage tap on the hydrokit.
2. Ensure that the drain hose is seated firmly. Use a hose clip to attach the hose, if necessary
(to be field-supplied).
3. Lay the drain hose with a constant slope into a suitable receptacle for the condensed water
(to be field-supplied).
Detail view from below
1
1
Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
1 Safety valve drainage tap
1 Safety valve drainage tap