Toshiba MMK-UP0271HP Series Service Manual page 24

No. Item
18 PRESET operation
(Wireless remote
control specific
operation)
19 DC motor
20
Save operation
Outline of specifications
To operate the air conditioner with the setting
memorized.
(1) Press the PRESET button. The setting memorized
will be indicated and the air conditioner operates
with regards to the setting.
• The lamp (White) on the display panel of the
indoor unit goes on, and operation starts after
approximately 3 minutes.
• Initial setting:
MODE : AUTO
Temperature : 22
(Memorized Setting)
(1) Select your preferred operation
(2) Press and hold
than 3 seconds. The
and the setting is memorized.
(3) Press the PRESET button to operate the
setting memorized.
(1) When the fan stator, positioning is performed for the
starter and the rotor. (Vibrate slightly)
(2) DC motor operates according to the command from
the indoor controller.
(Note)
If the fan lock was detected, the operation of the indoor
unit stops and the error is displayed.
(1) The save operation starts when
remotecontroller is turned on.
(2) While the save operation is performed,
goes on the screen of the wired remote controller.
(3) The request capacity ratio is restricted to approx.
75% during save operation.
(4) If the save operation was validated, the contents are
held during the operation stop, the operation mode
change and the resetting of power supply. Therefore
the operation at the next time also will be activated
with "Save operation is valid"
PRESET button more
make is indicated
P
button on the
SAVE
segment
- 24 -
Remarks
1
SWING FAN
FIX QUIET
Hi POWER
COMFORT
SLEEP
Check code [P12]
RBC-AMT32E