Table of Contents
Advertisement
LTPE-UG-1017-01 Issue 1
Configure LTU and NTU Interfaces
Select and configure the LTU- and NTU-related operating parameters as
follows:
1
Press one of the following keys at the Config drop-down menu to display
the Config LTU or NTU Interface menu:
•
L
for the Config LTU Interface menu (UTU-731 in
or UTU-732 in
•
N
for the UTU-731 or UTU-732 Config NTU Interface menu (the
fields and options displayed in the Config NTU Interface menu are
identical to those displayed in the Config LTU Interface menu).
Figure 15. UTU-731 Config LTU Interface Menu
The Data Rate/# of TSs and Beginning TS parameters in the
Config LTU and NTU Interface menus
The Data Rate/# of TSs value is set in the Config System
Settings menu as the "HDSL Payload Rate" (see
page
32 time slots are selected (unstructured mode) and set to 1
when less than 32 time slots are selected (structured mode).
UTU-731 List 1 and UTU-732 List 1
Figure 16 on page
27). The Beginning TS value is automatically set to 0 when
February 15, 2001
System Configuration
Figure 15
30).
are read-only displays.
below
Figure 14 on
29
Advertisement
Table of Contents
